HYDRAULIC THUMB ATTACHMENT CLAW KIT John Deere 35D & Hitachi ZX35 W/BASE PLATE

HYDRAULIC THUMB KIT ONLY NOT THE ENTIRE EXCAVATOR!!!RCM is excited to announce the release of a new hydraulic thumb for John Deere 35D, Hitachi ZX35. This kit is for machines that need the mount for the hydraulic cylinder on the boom.All of our thumb assemblies & hydraulic cylinders come with a 1 year warranty. This is a complete thumb kit including USA quality designed thumb designed. This thumb has two 3/4" thick AR400 steel tines this steel is made to last and will hold up to years of use. Our thumbs are specifically designed to fold up and out of the way when not in use. This thumb folds up well under 12”, that’s less than or tighter to the boom than even the factory designed models. Our thumbs also have over 130 degrees of rotational angle for maximum possible use. This kit comes with; thumb assembly, hydraulic cylinder, hydraulic quick connect couplers, (2) 90-degree hydraulic elbows, (2) hydraulic hoses, (2) hydraulic cylinder pins, and four lynch pins, a high strength main pin, and a mounting plate for hydraulic cylinder, (requires welding). The only item needed to install is thread tape.  We also send out clear installation instructions with all orders. This fits standard arm only, does not fit long arm or extendable arm. We provide a custom designed and engineered USA made 3500psi tested operates at 3000 psi, welded hydraulic cylinder with a 1 year warranty, 1.5" rod, ready to mount onto your machine.  Please let us know if there is not a cylinder mount on your machine already we also fabricated boom mounts if needed, for an additional fee.  The hydraulic cylinder also utilizes side ports so that the hoses connect out of the way.  All pins are included with this kit, the longer main pin is made from high strength steel, HT4140, turned ground and polished. USA steel to the exact dimension.  Grease fittings are provided at all pivoting locations and nested for protection from and material collision that may occur during use. We do not center drill out our main pins for a grease fitting.  We do not center drill main pins due to frequent breakages, these pins are longer and with a hole drilled in the center, the chances of them breaking significantly increase.  Instead we have grease fittings in the thumb bushings, and we highly recommend,  for these machines that you drill and install a grease fitting in the boom knuckle. This is the best method. This kit is designed for the John Deere brand bucket if you have a different brand bucket or quick connect please call first for dimension review. This kit is not for extendahoe or long arm machines! This kit is a great value, while offering incredible quality and design.  We have had great feedback and response to our design, fabrication quality, and customer service. We have been fabricating these thumbs as well as continually striving to improve our designs for many years. We are a family owned and run business and have been producing these thumbs for approximately 10 year. We will be here if you need us. If you are interested in a thumb for a different machine, please contact me so we can send you our custom order form.  We have many thumb designs not listed on ebay. Please contact me with any questions or call/text twozero8 53nine 93two1. Runser Custom Machining, Runsercm.com